Bi-telecentric lens for 2/3″ sensors, magnification 1.333 x, C-mount
Beğenilerine Ekle
Beğenilerine Ekle
Description
| Main optical specifications | ||
| Magnification | (x) | 1.333 |
| Image circle diameter | (mm) | 11.0 |
| Max sensor size | 2/3″ | |
| Object field of view | ||
| 1/3” (1) | (mm × mm) | 3.60 x 2.70 |
| 1/2.5” (1) | (mm × mm) | 4.28 x 3.21 |
| 1/2” (1) | (mm × mm) | 4.80 x 3.60 |
| 1/1.8” (1) | (mm × mm) | 5.35 x 4.00 |
| 2/3” (1) | (mm × mm) | 6.38 x 5.32 |
| Advanced optical specifications | ||
| Working distance (2) | (mm) | 60.1 |
| Working ƒ/N (3) | 11 | |
| Telecentricity typical (max) (4) | (deg) | < 0.08 (0.10) |
| Distortion typical (max) (5) | (%) | < 0.03 (0.08) |
| Depth of field (6) | (mm) | 0.30 |
| Resolution (7) | (μm) | 5 |
| Mechanical specifications | ||
| Mount | C | |
| Phase adjustment (8) | No | |
| Length (9) | (mm) | 78.5 |
| Front diameter | (mm) | 28 |
| Mass | (g) | 183 |
Last update 02 May 2024
- Object field of view (mm x mm). For the fields with the indication “Ø =”, the image of a circular object of such diameter is fully inscribed into the detector.
- Working distance: distance between the front end of the mechanics and the object. Set this distance within ±3% of the nominal value for maximum resolution and minimum distortion.
- Working f-number (wf/N): the real f-number of a lens in operating conditions.
- Maximum angle between chief rays and optical axis on the object side. Typical (average production) values and maximum (guaranteed) values are listed.
- Percent deviation of the real image compared to an ideal, undistorted image. Typical (average production) values and maximum (guaranteed) values are listed.
- At the limits of the depth of field, the image can still be used for measurements. For a very sharp image, however, only half of the depth of field should be considered. Pixel size used for calculation is 3.45 μm.
- Object side, calculated with the Rayleigh criterion with λ= 520 nm
- If not available, phase adjustment can be supplied upon request (except for TC23004, TC23007,TC23009, TC23012).
- Measured from the front end of the mechanics to the camera flange.
Uzmana Sorun !
