TC23009 – Opto Engineering Telecentric Lens

Bi-telecentric lens for 2/3″ sensors, magnification 1.000 x, C-mount

Beğenilerine Ekle
Beğenilerine Ekle

Açıklama

Main optical specifications
Magnification (x) 1.000
Image circle diameter (mm) 11.0
Max sensor size 2/3″
Object field of view
1/3” (1) (mm × mm) 4.80 x 3.60
1/2.5” (1) (mm × mm) 5.70 x 4.28
1/2” (1) (mm × mm) 6.40 x 4.80
1/1.8” (1) (mm × mm) 7.13 x 5.33
2/3” (1) (mm × mm) 8.50 x 7.09
Advanced optical specifications
Working distance (2) (mm) 62.2
Working ƒ/N (3) 11
Telecentricity typical (max) (4) (deg) < 0.08 (0.10)
Distortion typical (max) (5) (%) < 0.04 (0.08)
Depth of field (6) (mm) 0.60
Resolution (7) (μm) 7
Mechanical specifications
Mount C
Phase adjustment (8) No
Length (9) (mm) 65.0
Front diameter (mm) 28
Mass (g) 168

Last update 02 May 2024

REACH
  1. Object field of view (mm x mm). For the fields with the indication “Ø =”, the image of a circular object of such diameter is fully inscribed into the detector.
  2. Working distance: distance between the front end of the mechanics and the object. Set this distance within ±3% of the nominal value for maximum resolution and minimum distortion.
  3. Working f-number (wf/N): the real f-number of a lens in operating conditions.
  4. Maximum angle between chief rays and optical axis on the object side. Typical (average production) values and maximum (guaranteed) values are listed.
  5. Percent deviation of the real image compared to an ideal, undistorted image. Typical (average production) values and maximum (guaranteed) values are listed.
  6. At the limits of the depth of field, the image can still be used for measurements. For a very sharp image, however, only half of the depth of field should be considered. Pixel size used for calculation is 3.45 μm.
  7. Object side, calculated with the Rayleigh criterion with λ= 520 nm
  8. If not available, phase adjustment can be supplied upon request (except for TC23004, TC23007,TC23009, TC23012).
  9. Measured from the front end of the mechanics to the camera flange.
Uzmana Sorun !
Yer işareti koy Kalıcı Bağlantı.

Yorumlar kapatıldı.